NOTICE: ONCE SUMMIT BAR IS FITTED:
Ensure all bolts are tensioned correctly.
All wiring is clear of sharp edges or moving surfaces and secured
properly.
Piping is secured well away from sharp or moving components.
Check operation of winch, if fitted.
Check all wiring and connections to turn signal lamps, sensors,
headlamp washers etc. are functioning correctly.
Misalignment of parking sensor to hole in bull bar may cause
malfunction.
Test operation of parking sensors after fitment.
NOTE:
If parking sensors are fitted, do not add any accessories to the Bull Bar on
or around the sensors, this may affect the function of the sensors.
Sensors may not function well under the following conditions:
After the vehicle, has been sitting out in hot or cold weather.
When the system is affected by electrical equipment or devices
generating an ultrasonic wave.
When operating in bad weather
To Previous Page
Loading...
