Fitting instructions# 3789528
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
140. Ensure each buffer sits flat against the face of bar. Secure wing side using retaining clips. Secure
inner side using the angled cup washers, flat washers and screws.
The widest point of the cup washers goes to the top of the bar.
Fit washers under screw heads
Generic image. Bull Bar shown may
not be representative of actual product.
Generic image. Bull Bar shown may
not be representative of actual product.
To Next Page
Loading...
