Fitting instructions# 3789528
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
135. Insert the 6 x plastic grommets into the 6 square holes in the front face of the bar.
136. Insert the grille into the bar so that the hatches open outward (facing the front of the bar).
137. Attach the grille to the centre of the bar using the short screws into the grommets fitted above.
138. Attach the ends of the grille to the bar using the longer screws, through the clamp plates into the
remaining grommets.
139. Place each of the front buffer sections onto the bar as shown. Ensure that the 2 lugs and 2 screw
bosses pass through the holes in the bar.
Generic image. Bull Bar shown
may not be representative of
actual product.
Generic image. Bull Bar shown may
not be representative of actual product.
To Next Page
Loading...
