ARB 3940420 - Page 6

Last Rev Date 17/05/2019
Page 6 of 36
Fitting instructions# 3789528
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
FOR RANGER:
6. Undo and remove the screws and plastic clips
behind the grille near the lower inner edge of
the head lights.
FOR RANGER:
7. Remove the screws and clips holding the
inner grille air deflectors to the vehicle.
8. Retain air deflectors, screws and clips.
FOR RANGER:
9. Carefully remove all clips used to retain
bumper to crash beam.
FOR EVEREST:
10. On both sides undo and remove the screws
behind the grille near the lower inner edge of
the head lights.
FOR EVEREST:
11. Remove all the fasteners securing RH SIDE
outer trim panel to the vehicle and detach.
Discard the panel.
12. Repeat on LH Side