Arcam SA10 - Default Chapter; Table of Contents

2
Applicability
This document applies to the Arcam SA10/SA20 integrated amplifiers.
Revision history
Issue A.0: Initial revision
Issue B.0: Correction to 0x58
Controlling via RS232/NET ............................................3
Introduction ................................................................................... 3
Set-up ................................................................................................ 3
Conventions ................................................................................... 3
Serial cable specification ........................................................... 3
Data transfer format .................................................................... 3
Command and response formats .......................................... 3
AMX Duet™ support .................................................................... 4
System Command Specifications ...............................5
Power (0x00) ................................................................................... 5
Display brightness (0x01).......................................................... 5
Headphones (0x02) ..................................................................... 6
Software version (0x04) ............................................................. 6
Factory reset (0x05) ..................................................................... 7
Simulate RC5 IR command (0x08) ......................................... 7
Volume (0x0D) ............................................................................... 8
Mute/unmute (0x0E) ................................................................... 8
Current input source (0x1D) .................................................... 9
Headphone override (0x1F) ..................................................... 9
Heartbeat (0x25) .........................................................................10
Reboot (0x26) ..............................................................................10
Balance (0x3B) .............................................................................11
Incoming audio sample rate (0x44) .................................... 11
DC offset (0x51) ...........................................................................12
Short circuit status (0x52) (SA20 only) ............................... 12
Friendly name (0x53) ................................................................13
IP address (0x54) ......................................................................... 13
Timeout counter (0x55) ...........................................................14
Lifter temperature (0x56) (SA20 Only) ............................... 14
Output temperature (0x57)....................................................15
Auto shutdown control (0x58) ..............................................15
Input detect (0x5A) ....................................................................16
Processor mode input (0x5B) ................................................16
Processor mode volume (0x5C) ...........................................17
System status (0x5D) .................................................................17
System model (0x5E) ................................................................18
DAC Filter (0x61) .........................................................................18
RC5 Command Codes ...................................................19
Basic Functions ............................................................................19
Advanced Functions .................................................................19
Contents