AREMDE NEXUS - Installation Notes

20
5.0 SETTING UP NEXUS/STYLUS
5.3 Installation Notes
• Nexus/Stylus can be supplied as a single or multi-phase appliance. Please conrm your connections
before installing the unit.
• If it is necessary to use parts and materials (external to the machine) not supplied with the equipment,
it is important that the installing technical personnel check the suitability for use with human contact,
and is in line with the local regulatory body.
• This machine must be installed according to the local and federal codes and standard of practice,
including any regulatory mandated back ow prevention device if required. For this reason we
recommend the plumbing connections to be carried out by a qualied technical person.
• Aremde strongly recommends that water quality suitable to preserve the integrity and longevity of the
machine be used. Failure to do so will invalidate warranty on the equipment. Water quality must be of
a standard acceptable for human consumption. The installing technical person MUST ensure the water
complies with all mandated regulatory requirements.
• We recommend using Reverse Osmosis water - BWT Reverse Osmosis water ltration systems can be
ordered through info@aremde.com.au.
The compliance plate is located on the rear of the UCU or on the underside of the CTU corner. At the start
of this manual, the information specically required to install and setup this equipment is provided.