29
3. Turn on switch A – machine will beep and complete auto ll and start lling and rinising group heads
for up to 70 seconds.
Note: This function is set as a default when the machine is switched on for the rst time. To
initiate this function again, the reset button should be held until the machine turns off, then
the enter button should be held until the machine turns on. The start up function will initiate
upon start up, please refer to section 6.0 PROGRAMMING AND SET UP for location of buttons.
4. Turn on switch B and C, machine lights will turn on and machine will start heating.
5. Wait until rated operating conditions (set at factory: pressure 1.2 bar, group temperature 93.4°C) are
reached and machine is ready for operation.
6. Once rated operating conditions are reached, let steam run through wands freely for 30 seconds.
5.0 SETTING UP NEXUS/STYLUS
To Next Page
Loading...