56
8.0 OPERATING WEXUS - NEXUS MODELS ONLY
Note: After setting Weighing Resolution to high, the default display will show [ 0:00 0.00 ]
with timer in Dual Display Mode and Auto Start Modes.
Reset To Default Setting [ rESEt.d ]
1. Select [ YES ] to set all setting to default value. Bluetooth Setup Setting [ bt_SEt ]
2. Toggle ON/OFF to set Bluetooth connectivity ON/OFF.
Setpoint Offset Setting [ OFFSET ]
1. Set the offset parameter for setpoint offset. The larger the offset, the earlier Nexus will stop before
reaching the actual target weight.
2. Available parameters: 2, 3, 4, and 5.
Tare Delay Setting [tArE.d]
1. Set the delay between starting an Espresso shot and the tare command sent to the Acaia Lunar.
2. Available parameters: 0,1, 2, 3, 4, and 5.
Pre-Infusion Time Out [ PrE_inFu ]
1. Determines when the scale times start in all three of the Auto-Start modes. This is most useful for long
pre-infusion times and resolves the timeout that sometimes happens for slow
pre-infusion times.
To Next Page
Loading...