Operation Guide P341/EN O/B11
Commissioning and CHAPTER 3
Maintenance Page 45/80
MiCOM P341
091A
V Vector Shift
Disabled/Enabled*
091C Reconnect Delay Disabled/Enabled*
091D Volt Protection Disabled/Enabled*
091E Freq Protection Disabled/Enabled*
0920 CB Fail Disabled/Enabled*
0921 Supervision Disabled/Enabled*
0924 Pole Slipping Disabled/Enabled*
0925 Input Labels Invisible/Visible*
0926 Output Labels Invisible/Visible*
0928 CT & VT Ratios Invisible/Visible*
0929 Event Recorder Invisible/Visible*
092A Disturb Recorder Invisible/Visible*
092B Measure’t Setup Invisible/Visible*
092C Comms Settings Invisible/Visible*
092D Commissioning Tests Invisible/Visible*
092E Setting Values Primary/Secondary*
0A00 VT AND CT RATIOS
0A01 Main VT Primary
0A02 Main VT Sec’y
0A05 NVD VT Primary
0A06 NVD VT Sec’y
0A07 Phase CT Primary
0A08 Phase CT Sec’y
0A0B SEF CT Primary
0A0C SEF CT Sec’y
0B00 RECORD CONTROL
0B04 Alarm Event Disabled/Enabled*
0B05 Relay O/P Event Disabled/Enabled*
0B06 Opto Input Event Disabled/Enabled*
0B07 System Event Disabled/Enabled*
0B08 Fault Rec Event Disabled/Enabled*
0B09 Maint Rec Event Disabled/Enabled*
0B0A Protection Event Disabled/Enabled*
0B0B DDB 31 - 0
To Next Page
