AZI Sales/Customer Service 800-528-7411 or 602-470-1414 or support@azic.com Page 71 of 105
8.4.2.A Report Control Options
To get here, navigate:
[MENU]SETUP MENUREPORT SETUPREPORT CONTROL OPTIONS
Report control options determine how
often during a test a report is generated
and sent to the printer, computer or drive.
The following options are available:
• REPORT ENABLED enables a final
report after a test and an optional
progress report during a test, as
explained in REPORT START below.
• REPORT START:
o Test Start prints a progress report beginning at the start of a test along with the
final results. This is useful while developing a test program.
o First Prediction prints a progress report beginning at the start of the first prediction
along with the final results.
o Test End only prints the final results after a test.
• REPORT INTERVAL determines how often the progress report data is printed. Times
of 1, 5, 10, 15, and 30 seconds or 1 minute are available. The short durations are
good for test program development and the long intervals are good for normal use.
• INCLUDE GRAPH prints a moisture graph after the final results. Graphic data is not
sent to the computer or USB drive, however, only to the printer. Only the MAX
®
4000XL has Test Graphs.
To Next Page
Loading...
Need help?
General
