Armfield Instruction Manual
22
3. Connect the inlet to a supply of cold water using a standard ½” / 12.5mm
length of standard hose (not supplied by Armfield), and secure using a
suitable clip (not supplied).
4. Connect the tubing supplied with right-angle (90°) Guest push fittings to the
valves SOL2 and SOL3 beside the large process vessel.
5. Use the electrical cable provided, connect the power socket at the rear of the
plinth to a suitable mains electricity supply.
6. Check that the RCD and circuit breakers at the back of the equipment are in
the ON (up) position:
To Next Page
Loading...