Installation
23
7. Load the PCT40 software (Start>Programs>Armfield Process Control
Software>Basic Control Unit PCT40-306) then choose section 11: Project
Work.
Note: Individual exercises can be selected from the menu when it is required
to demonstrate a particular type of process control. Project work allows all
inputs and outputs to be viewed and operated simultaneously and so is
chosen to demonstrate operation of the various components.
8. The on/off switch for the apparatus is located on the orange panel on the front
of the plinth. Switch on the apparatus.
Note: The red and green LCD indicators on the front of the plinth are
associated with the USB connection to the PC. These may be lit even if the
PCT40 unit itself is switched off.
9. Using the flexible tubing provided, plumb the system as shown to allow
testing of the apparatus.
To Next Page
Loading...