Armfield Instruction Manual
42
Connections using flexible tubes
A set of flexible tubes is supplied with the PCT40. The tubes vary in material, length
terminations etc and are used in different applications on PCT40. The tubes are
listed below with a brief description and details of their application.
2 x 2.5m long flexible silicone rubber tube, 6.3mm bore, 1.6mm wall (Unsealed
quick release fittings both ends). Used in peristaltic pumps A and B.
2 x 2m long flexible clear PVC tubes (90 degree Guest push fitting / plain end).
Used to connect outlet of SOL2 and SOL3 to drain
2 x 1m long flexible clear PVC tubes (Sealed quick release fittings both ends).
Used to connect between different vessels / control devices.
1 x 2m long flexible clear PVC tube (Guest push fitting / plain end). Used to
connect T4 or P3 to drain.
1 x 1m long flexible clear PVC tube (Guest push fitting / unsealed quick release
fitting). Used for connecting inlet of coil (T2) to control device E.g. SOL1.
1 x 2m long flexible clear PVC tube (Unsealed quick release fitting / Guest push
fitting with flow control valve). Used to connect outlet of coil (T3) or small process
vessel to drain with valve to vary flowrate when required.
1 x 1.5m long flexible clear PVC tube (9 mm ID, Plain end / plain end). Used to
connect drain valve in moulded channel to drain
1 x 4m long flexible clear PVC tube (Unsealed quick release fitting / Guest push
fitting). Used as a holding tube when connected between T3 and T4.
To Next Page
Loading...