7-28 CHP Max™ Headend Optics Platform Chassis, Controllers and Power Supplies Rev D
10. When the next Internet Protocol (TCP/IP) Properties window appears, click on the
Use the following IP address: option, then type the following addresses into the
following fields (refer to Figure 5.25):
– IP address: 10.10.10.5
– Subnet mask: 255.255.255.0
–Default gateway: 10.10.10.1
Figure 7.25
Internet Protocol
(TCP/IP) Properties
Window
11. Click on the OK button.
Now you can use any telnet software (for example, PuTTY) to communicate via telnet with the
SMM-2.
To set the network information, proceed as follows:
1. After login, at the admin@192.168.1.1> prompt, type configure and press the Enter
key.
2. At the admin@192.168.1.1% prompt, type set interfaces and press the <TAB> or
<SPACE> followed by ? to view all the parts of the IPv4 address command:
eth0 sets the IPv4 address
mask sets the IP subnet mask
gateway sets the default gateway
Note The admin@192.168.1.1> prompt is an example and the prompt you are likely
to see will be different.
To Next Page
Loading...
