ARTURIA – CS-80V – USER’S MANUAL
41
Open modulation hatch
There are ten modulation controls available. For each modulation, the source must be
selected from 12 choices, and the destination in a list of 38 choices, by clicking on the
«SOURCE» and «DESTINATION» displays. The «AMOUNT» knob sets the rate of
modulation.
The sources of modulation are as follows:
LFO1 : low frequency oscillator of the first line
LFO2 : low frequency oscillator of the second line
SubOsc : general low frequency oscillator
EG Filter1 : envelope of the filters of the first line
EG Amp1 : envelope of the VCA of the first line
EG Filter2 : envelope of the filters of the second line
EG Amp1 : envelope of the VCA of the second line
Velocity : Velocity of the MIDI note
AfterT : Pressure of the MIDI note (After Touch)
Ribbon : ribbon
Wheel : modulation wheel
FootExp : Expression pedal
Off : no modulation
The modulation destinations are as follows:
VCO 1 Freq : frequency of the oscillator of the first line
VCO 1 PW : pulse width of the oscillator of the first line
Noise level1 : noise level of the first line
Noise level2 : noise level of the second line
VCO 2 Freq : frequency of the oscillator of the second line
VCO 2 PW : pulse width of the oscillator of the second line
HP 1 cutoff : high pass filter cut-off frequency of the first line
HP 1 res : resonance of the high pass filter of the first line
LP 1 cutoff : low pass filter cut-off frequency of the first line
LP 1 res : resonance of the low pass filter of the first line
HP 2 cutoff : high pass filter cut-off frequency of the second line
HP 2 res : resonance of the high pass filter of the second line
LP 2 cutoff : low pass filter cut-off frequency of the second line
LP 2 res : resonance of the low pass filter of the second line
VCA 1 Level : VCA level of the first line
VCA 2 Level : VCA level of the second line
SIN 1 Level : level of the sine of the first line
SIN 2 Level : level of the sine of the second line
LFO 1 Speed : frequency of the LFO of the first line
To Next Page
Loading...