Aruba S2500 Series Mobility Access Switch | Installation Guide Installation | 27
Figure 14 Mounting the S2500
Table or Shelf Installation
Required Tools and Equipment
Rubber Feet (included)
Installation Steps
1. Attach the included rubber feet to the bottom of the mobility access switch.
2. Place your mobility access switch in the location you have chosen.
3. Connect the AC power cord to the rear of the unit.
4. Plug the opposite end of the power cord into an electrical outlet to power the mobility access switch.
Connecting the AC Power Cord
Once you have installed the S2500, you are ready to power on the device. The S2500 is not equipped with an
On/Off switch. The device will turn on when the AC power cord has been connected to the power supply
module and an AC power outlet.
To connect the AC power cord:
1. Lift the power cord retaining clip so it is not blocking the AC power connector.
To Next Page
