ASCOM Ascotel 2025 - Page 1007

ascom Ascotel 2025/2045/2065
7.8 Data Maintenance HBT_20321104_07/B0_en
Setting
The connection parameters for a software upload are set using "PBX connection /
Setting".
• Connection parameters for local access:
– IP address of the PBX for dial-up networking connections (redundant if the
IP address has already been configured in CM under "Dial-up IP configura-
tion")
– Dial-up networking; information on dial-up networking (see "Settings on
the PC", Page 5.8)
– Terminal; "Ascom Direct PPP Connection"
• Connection parameters for dial-up access:
– IP address of the PBX for dial-up networking connections (redundant if the
IP address has already been configured in dial-up networking; see IP config-
uration, IP setup PPP / dial-up networking server)
– Dial-up networking; information on dial-up networking (see "Settings on
the PC", Page 5.8)
– Device; ISDN card or TA connection parameter LAN
• Connection parameters for local access Xmodem port:
– Communication port number of the PC (COM1 initialization value)
– Transmission rate (initialization value 9 600)
– Number of data bits (initialization value 8)
– Party (initialization value None)
– Stop bits (initialization value 1)
– Flow control (initialization value RTS / CTS)
• Connection parameters for LAN
– IP address of the PBX for LAN connections (redundant if the IP address has
already been configured in CM under "LAN IP configuration")
See also:
For further information on parameter configuration see "Settings",
Page 5.7).