ASCOM d41 Configuration Manual

TD 92641EN
21 June 2012 / Ver. G
Configuration Manual
Ascom d41 DECT Handset
12
• If a handset needs to be replaced due to for example a broken display, see User
Manual, Ascom d41 DECT Handset, TD 92582GB.
• If the electrical connection is damaged, it might not be possible to follow the Easy
Replacement procedure. Depending on fault, it might work to do a replacement via
PDM/IMS3, see 4.7 Replacement of handset with the IMS3 on page 12 or 4.8
Replacement of the handset with the PDM Windows Version on page 13.
• If two handsets and their settings shall be switched between two users, follow 4.7
Replacement of handset with the IMS3 on page 12 or 4.8 Replacement of the handset
with the PDM Windows Version on page 13.
4.7 Replacement of handset with the IMS3
Both the old handset and the new handset must be of the same device type (d41). The
same extension number is assigned to the new handset.
Make sure that the old handset is saved in the IMS3. Start the Device Manager in the IMS3
and navigate to the "Numbers" tab. There shall be a tick in the "Saved" column for the
old handset.
If the handset is not saved, insert it into a desktop charger or rack charger connected to
IMS3 and perform a save, see Installation and Operation Manual, IMS3, TD 92762EN.
If it would be impossible to save the old handset settings, stop this replacement
procedure. Instead unsubscribe the old handset from the PBX, register the new handset
and follow the instructions for installing a handset, see 3.2 Installation of a new Handset
on page 5. When the handset is saved, unsubscribe the old handset from the PBX.The
following steps are described in two different scenarios, check which one suits the best
before proceeding.
4.7.1 Data included in a replacement transfer
The following data is replaced during a replacement with IMS3:
• User parameters (including User ID)
• Contacts (entered by the user)
Note that the following data is not replaced:
• DECT registration
• Call list
• Company phonebook
• Downloaded Language
• Licenses
1
4.7.2 Handset Replacement with IMS3 in DECT or IP-DECT System (release 3.1.x or
higher)
Note: The handset to be installed must not have any previous valid registrations. If it has a
valid registration, unsubscribe the handset or follow the instructions in 4.7.3 Handset
Replacement with IMS3 in DECT or IP-DECT System (release 3.0.x or lower) on page 13.
1. A handset’s product license (that is, d41 Advanced) can be moved to a d41 Basic using the Move license function in
the IMS3.

ASCOM d41 Specifications

General

Type	DECT telephone
Answering machine	No
Mounting type	-
Product color	Gray
Speakerphone	Yes
Phonebook capacity	500 entries
Languages support	CZE, DAN, DEU, DUT, ENG, ESP, FIN, FRE, GRE, HUN, ITA, NOR, POL, POR, RUS, SLK, SWE, TUR
Standby time	180 h
Battery recharge time	4 h
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Number of handsets included	1

Weight and Dimensions

Depth	24 mm
Width	53 mm
Height	133 mm