TD 92641EN
21 June 2012 / Ver. G
Configuration Manual
Ascom d41 DECT Handset
30
SERVICE NEEDED
Invalid IPDI
Note: This display message is
only shown in English.
Easy replacement procedure
not followed correctly or
failure during easy
replacement procedure.
Send the handset for service.
Enter PIN code Phone lock is activated. Enter the required PIN code.
If the PIN code has been lost,
enter a new PIN code via the
PDM/IMS3 or do a factory
reset via the PDM/IMS3.
Battery low, charge now The battery level is low. Charge the handset, or
replace battery.
Phonebook is not available at
the moment.
The phonebook is not
activated or does not
respond.
Try again later or if the fault
persists do a factory reset via
the admin menu or via the
PDM/IMS3.
Note that it may take several
minutes for the phonebook
to be available if there are
many entries in Contacts
and/or company phonebook.
Voice mail number not
defined
There is no Voice mail
number defined in the
handset.
Define a Voice mail number
via the PDM/IMS3.
Could not encrypt
connection
The parameter "Encryption
Required" is enabled in the
handset in combination with;
1) Unencrypted base
station(s); and/or,
2) Unsupported base
station(s).
1) Disable the "Encryption
Required" parameter in
handset; and/or,
2) Enable the encryption in
the base station(s); and/or,
Note: If Ascom’s base
station(s) is used, the
software version must be
3.1.x or greater.
3) Use supported base
station(s). Ask your supplier.
License key not accepted 1)The license key is to short/
long
2) The license key is not valid.
1)Make sure that the license
key consists of 29 digits.
2) Generate a valid license
using the License Web.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
