ASCOM Elise3 User Manual

TD 92679GB
12 April 2011 Ver. D
Installation Guide
Elise3
9
3.4.2 Boot Mode
When the application running on Elise3 cannot be accessed the module can be set in Boot
Mode i.e.the web interface of the module. From this GUI it is possible to install new
software, start Troubleshoot Mode, see settings and to reset the module back to factory
default settings.
1
Placing the module in Boot Mode is performed manually by the user but if the module
detects several major errors the module can place itself in Boot Mode. Refer to chapter
5 Working in Boot Mode on page 25.
3.4.3 Demonstration Mode
Demonstration Mode makes it possible to run the Elise3 for two hours with full or almost
full functionality, with or without a valid license. Exact functionality is application
dependent. For more information about the functionality during demonstration mode, see
the application documentation.
Refer to chapter 6 Run in Demonstration Mode on page 28.
3.4.4 Troubleshoot Mode
Troubleshoot Mode makes it possible to troubleshoot the system and access log files when
it is impossible to access and troubleshoot in the application running on Elise3, i.e. in
Troubleshoot Mode no application is started.
Troubleshoot Mode is started from the Boot Mode GUI, see 8.1 Troubleshooting from
Boot Mode on page 32.
1.Network settings such (IP address, Host name, etc.) will not be changed when resetting back to factory default.

ASCOM Elise3 Specifications

General

Brand	ASCOM
Model	Elise3
Category	Server
Language	English