TD 92679GB
12 April 2011 Ver. D
Installation Guide
Elise3
28
6 Run in Demonstration Mode
The Demonstration Mode can be set when the module is running in normal operation,
either via the application's web interface or manually by using the Mode button.
Using the Mode button:
1 Press and hold the Mode button for 10 seconds.
Demonstration Mode is indicated by the Status LED with slow flashing yellow light
and by the Mode button LED with fixed blue light .
The module will automatically return to the previous license and parameters (without
restart) after 2 hours.
Exiting before the 2 hours have passed, is done from the application's web interface, refer
to the application documentation. Restarting the Demonstration Mode after exiting, can
be done from the application's web interface after a delay of 10 minutes, but an
immediate restart can be done by using the Mode button.
To Next Page
Loading...
