TD 92679GB
12 April 2011 Ver. D
Installation Guide
Elise3
4
2 General Information
2.1 Licenses
All Elise3 modules must have a valid software license. The license number can be found in
the application’s GUI in the Setup Wizard, on the Configuration page (the first view), on
the Advanced Configuration page in System Setup > Common > License. New licenses are
downloaded from the Ascom extranet (https://www.ascom-ws.com).
2.2 The MAC Address
The MAC address can be found on a label on the products rear side, in the application’s
GUI in the Setup Wizard, on the Configuration page (the first view) and on the Advanced
Configuration page in Troubleshoot > System Information. It is also found in the Boot
Mode GUI under System > Information.
2.3 Authentication and Administration
Administration is done via a web browser. The administration pages require a user name
and password.
IMPORTANT: The default passwords need to be changed to prevent unauthorized access
to the administration pages.
2.3.1 Authentication
GUI pages on the Elise3 module always have two different user accounts; “admin” and
“sysadmin”. Some applications also have additional accounts called “user” and “ftpuser”.
The admin account with the default password “changeme”, is used for administration and
simple troubleshooting of the module. The admin has permission to change all passwords
except the sysadmin password.
The sysadmin account with the default password “setmeup”, is used for advanced
troubleshooting. The sysadmin has access to all administration pages and has permission
to change passwords for all users.
The additional account user with the default password “password”, is found in some
Elise3 applications. This user is application dependent and the field of application is
described in the corresponding application documentation. This user does not have access
to the administration pages where passwords normally are changed, but the user can
change its own password on the following page; http://xxx.xxx.xxx.xxx/admin/public/
user_chpass.shtml. The password can also be changed by the admin and sysadmin.
The additional account ftpuser with the default password “changemetoo”, is found in
some Elise3 applications. The user is available in products with an FTP area. This user can
change its own password on the following page; http://xxx.xxx.xxx.xxx/admin/public/
ftpuser_chpass.shtml.
2.3.2 Administration
The application’s Advanced Configuration page requires the admin account. The page can
be reached directly by entering “xxx.xxx.xxx.xxx/admin” in the address bar, where
xxx.xxx.xxx.xxx is the modules IP address. For applications having a start page, it can also
be reached by pressing the “Configuration” button on the start page and then selecting
Other Settings > Advanced Configuration.
To Next Page
Loading...
Need help?
General
