AC24/30/36 Operations Manual....
19
5.2.1 Input Power Connections
The converter is supplied with compression type terminal blocks for input power connections.
These terminal blocks accept wires in the range of 2/0 to 8AWG. Refer to the applicable standards
for selection of required wire gauge and type.
If only a single shore cord is to be used, it must be connected to the SHORE POWER 1 INPUT
terminal block. The inputs to each system are fully isolated with no phase orientation requirements
to the input power service if dual shore cords are used.
FIGURE 3 ELECTRICAL CONNECTIONS
To Next Page
Loading...
