ASEA AC24 - Quick Setup of Shore Cord Alarm

AC24/30/36 Operations Manual....
42
7.3 LOAD MANAGEMENT OPERATION, cont.
7.3.5 Quick Setup of Shore Cord Alarm
1. Turn the converter red disconnect switch ON and wait 15-20 seconds for initialization.
2. Press the SHORE POWER + F2 buttons.
3. Press the Cursor (F4) button to advance to the ALARM AT % setting.
4. Set the converter ALARM AT % using the More/Less (F1/F2) buttons.
5. Press the Cursor (F4) button to advance to the ALARM enable setting.
6. Set the converter ALARM enable using the Enable/Disable (F1/F2) buttons.
7. Press the Exit (F5) button to save the settings and exit.
8. Turn ON the converter and place on-line as usual. Alarm will occur when loading reaches the
ALARM AT % setting.