AC24/30/36 Operations Manual....
21
5.2.2 Output Power Connections, cont.
For 220V, 230V, or 240V single-phase systems, connect the converter’s L1 terminal to the electrical
system’s hot conductor at the distribution panel. Connect the converter’s L2 terminal to the
electrical system’s Neutral conductor at the distribution panel. The 220V output voltage will be
developed between terminals L1 and L2. If the converter output is to be grounded, ground L2 at the
converter panel or at the distribution panel. If the electrical system is to remain isolated from the
ship’s ground, connect the converter’s L2 terminal to the distribution panel as the second hot
conductor. Under no circumstance should L1 be connected to ground, or any connection made to
the “N” terminal.
To Next Page
Loading...
