AC24/30/36 Operations Manual....
7
THIS EQUIPMENT CONTAINS HIGH ENERGY, LOW IMPEDANCE
CIRCUITS! LETHAL POTENTIALS ARE CONTAINED WITHIN THE
SYSTEM EVEN WHEN IT IS APPARENTLY NOT OPERATING.
CARE MUST BE EXERCISED WHEN SERVICING THIS EQUIPMENT IN
ORDER TO PREVENT SERIOUS OPERATOR INJURY OR EQUIPMENT
DAMAGE.
DO NOT WORK ON OR OPERATE THIS EQUIPMENT UNLESS YOU ARE
FULLY QUALIFIED TO DO SO. NEVER WORK ALONE.
THE EQUIPMENT IS NOT IGNITION RATED, IT MUST NOT BE
OPERATED IN AREAS WHERE COMBUSTIBLE GASES MAY
ACCUMULATE.
OBSERVE THE FOLLOWING WHEN SERVICE AND MAINTENANCE
ARE REQUIRED:
REMOVE ALL JEWELRY FROM ARMS AND NECK WHEN SERVICING
THIS EQUIPMENT. THIS PREVENTS THE POSSIBILITY OF
SHORTING THROUGH THE JEWELRY, OR ELECTROCUTION OF THE
OPERATOR.
WEAR SAFETY GLASSES WHEN SERVICING THIS EQUIPMENT
TO PREVENT EYE INJURY DUE TO FLYING PARTICLES
CAUSED BY ACCIDENTAL SHORT CIRCUIT CONDITIONS.
DO NOT REMOVE ANY PANELS OR COVERS WITHOUT FIRST
OPENING ALL CIRCUIT BREAKERS AND THEN REMOVING
THE INPUT SERVICE.
SERVICE OTHER THAN CLEANING AIR FILTER ELEMENTS
SHOULD BE REFERRED TO PERSONNEL AUTHORIZED BY
THE FACTORY TO SERVICE THIS EQUIPMENT.
To Next Page
Loading...
