VIPEDIA-12 Products – Installation Guide
U-0641-0344.docx – Issue: 8 complete, approved
Page 31 of 52
7.3.1.5 BOA01 - Contact Outputs (1 to 12) Connections
Field Connection
Connection to VIPEDIA-12
(via CAT5 patch lead)
Screw Terminal
①
From
external
power supply
Description Signal Pin
Not applicable
(Connected to screw terminal
③
via the PCB.)
+V supply input (18 – 40 V) / 500 mA 24 V 1
+V supply input (18 – 40 V) / 500 mA 24 V 2
0 V supply 0 V 3
To/From
external
device
Screw Terminal
②
BOA01’s
RJ45
(see page 25)
④
VIPEDIA-12’s
RJ45
(see page 16)
②
Description Signal Pin Pin T568B Pin
Open-drain output 1 [7] Contact 1 [7] 1 1 WH/OR 1
Open-drain output 2 [8] Contact 2 [8] 2 2 OR 2
Open-drain output 3 [9] Contact 3 [9] 3 3 WH/GR 3
Open-drain output 4 [10] Contact 4 [10] 4 6 GR 6
Open-drain output 5 [11] Contact 5 [11] 5 4 BL 4
Open-drain output 6 [12] Contact 6 [12] 6 5 WH/BL 5
+ve supply (as 18V-40 V power supply
input) for open-drain outputs
+Supply 7 7 WH/BR 7
+ve supply (as 18V-40 V power supply
input) for open-drain outputs
+Supply 8 8 BR 8
Screw Terminal
③
Not applicable
Description Signal Pin
Cable screen SCREEN 1
DC supply output (18 – 40 V) SUPPLY+ 2
Cable screen SCREEN 3
DC supply output (0 V) 0V 4
Cable screen SCREEN 5
DC supply output (18 – 40 V) SUPPLY+ 6
Cable screen SCREEN 7
DC supply output (0 V) 0V 8
1) An external DC power supply (18 – 40 V) must be connected to screw terminal ① if the open-drain outputs
are to be powered from the screw terminal block
③.
2) Open-drain output:
• Numbers without brackets refer to CONTACTS OUT 1-6 connector
• Numbers within brackets refer to CONTACTS OUT 7-12 connector
To Next Page
Loading...
Need help?
General