VIPEDIA-12 Products – Installation Guide
U-0641-0344.docx – Issue: 8 complete, approved
Page 51 of 52
10 Storage and Preservation
This product should be packed for storage in the original packing as described in the Section “10 Packing for
Return” below and stored in the following environmental conditions:
• Away from harsh environmental conditions, such as areas that are subject to corrosive atmosphere,
excessive moisture or may allow water or other liquids to come into contact with the unit or its external
connections.
• In a heated and humidity controlled storage areas where the temperature and humidity are within the
equipment specification.
11 Packing for Return
This product contains static-sensitive devices. Observe ESD precautions when handling this
product with the cover removed.
If a product is being returned for servicing, try to use the containers and materials of the original packaging.
Attach a tag indicating the type of service required, return address, equipment type and full serial number.
If the original packing can no longer be used, the following general instructions should be used for repacking
with commercially available materials:
• All electronics assemblies must be properly packed in ESD protective packing for transport, to prevent
physical and ESD damage.
• The filler material used for packing must be antistatic or static dissipative, as this may come into contact
with exposed connectors, wiring, or PCB assemblies. The use of non-conductive filler material may
cause damage to the electronic assemblies reducing their operational life, or even destroying them.
• Use a sturdy cardboard box that will support the weight and size of the equipment.
• Attach a tag indicating the type of service required, return address, equipment type and full serial
number.
• Completely wrap the equipment in bubble wrap (all sides must be protected) and secure the wrap in
place with tape.
• Place the wrapped equipment inside the box surrounded by filler material, ensuring that there is no room
for movement.
• Seal the box securely with packing tape.
To Next Page
Loading...
Need help?
General