VIPEDIA-12 Products – Installation Guide
U-0641-0344.docx – Issue: 8 complete, approved
Page 9 of 52
2 Preparation
Read and observe the safety instructions and guidelines in Section “1 Safety and Precautions”
Failure to follow these instructions and guidelines may cause personal injury and/or damage to
the
equipment.
Gather the following documentation and tools:
• The system design documentation of the specific location
• A small flat-bladed screwdriver
• Pozidriv screwdrivers (No 1 and 3)
• A pair of wire cutters/strippers
• Ferrules and crimping tool
3. Gather the equipment (in its original packing).
A standard 19-inch rack is required for the installation.
The rack should be fitted with supporting rails, ventilation panels, and wired with power supply, signal,
and control wiring to suit the requirements of the specific system design. It should meet the rules and
guidelines provided in the VIPEDIA-12 Rack Design Guide (ASL T-0667-0185).
-12 is intended to be table or shelf mounted, i.e. not in a 19-inch standard
rack, then the unit should always be fitted into a 19
-inch desk case or flight case. This is to
prevent ingress of dust or debris that may
otherwise occur over a period of time.
DIN rail mounting Break-Out Adaptors (BOA) are available for easier rack wiring.
BOA01 (ASL P/N A0641006)
Screw terminals: external wiring
RJ45: VIPEDIA-12
EOL and ANS resistors: factory fit option
BOA02 (ASL P/N A0664244)
Screw terminals: external wiring
RJ45: VIPEDIA-12
To Next Page
Loading...
Need help?
General