44
Confirm Password
In order to complete the password entry, the password must be confirmed by retyping
the password into the Confirm Password parameter. To confirm the password, use the
up and down arrow keys to select the Confirm Password parameter. Use the
alpha/numeric keypad to retype the password.
Once the password is entered, it is necessary to complete the edit either by pressing
the ENTER key to accept the new password or the EXIT key to escape from the edit
and delete the password. NOTE: Once the ENTER key is pressed, the User ID will be
set. Edit the Security Level parameter prior to confirming the password.
Security Level
From the Add User screen, press the “Security Level” soft key. As the soft key is
pressed, the “Security Level” pop up screen will appear as follows:
Use the up or down arrow keys to select the Security Level.
Once a parameter is edited, it is necessary to complete the edit either by pressing the
ENTER key to accept the new value or the EXIT key to escape from the edit and
return to the original value.
The security levels are as follows:
Run Only: This is the most restricted mode of user access. The user can only
initiate a test, reset a failure or abort a test from the Perform Tests screen.
NOTE: whenever a user’s security level is Run Only, “Single Step” and “Fail
Stop” soft keys will be disabled at the Perform Test screen.
To Next Page
Loading...
Need help?
General
