56
To enter a text prompt, use the alphanumeric keypad. At the text prompt edit, the
letter or symbol will be inserted at the point where the cursor is flashing. The cursor
will then increment to the next position and wait for an additional character insertion.
If you make a mistake or want to change the character, press the backspace key in
the alphanumeric keypad. The cursor will decrement and erase the character. If you
wish to use capital letters in the prompt, press the “Caps Lock” soft key. While
pressing the Caps Lock soft key, the Caps Lock parameter will toggle between ON
and OFF. If you wish to use symbols in the prompt, press the “Symbol Key” soft key.
While pressing the Symbol Key soft key, the symbol values will toggle between !, *, _,
- and ~.
When you have finished editing the prompt press the ENTER key. After a prompt is
inserted in a step, a “P” will appear within the step parameters below the step number.
4.3.5. File
From the Setup Tests screen, press the “File” soft key. The File Setup screen will
now be displayed. From the File Setup screen, five different file-handling controls
may be accessed: New File, Save, Save As, Delete, and Load. The File Setup screen
will appear as follows:
New File
From the File Setup screen, press the “New File” soft key. The Create File screen will
now be displayed. For a detailed description of creating a new file, refer to the section
4.5. Setting Up a Test. The Create File screen will appear as follows: