ASTECH LDM41A - Page 27

LDM41A and LDM42A Manual Commands and Parameter
ASTECH GmbH Page 27
SF
Queries/set scale factor
SE
Queries/set Error Mode (0, 1, 2)
AC
Queries/set alarm center
AH
Queries/set alarm hysteresis
AW
Queries/set alarm width
HO
18
Queries/set temperature for heating on
HF
18
Queries/set temperature for heating off
RB
Queries/set beginning of range (4 mA)
RE
Queries/set end of range(20 mA)
RM
Queries/set removal measurement parameters
TD
Queries/set trigger delay and level
TM
Queries/set trigger mode and level
BR
Queries/set baud rate
AS
Queries/set auto start
OF
Queries/set offset
SO
Sets current distance as offset
LO
Turns Laser on
LF
Turns Laser off
PA
Displays all parameter values
PR
Resets all parameters to standard values (don't use)
18
Only for devices with internal heating (LDM41A-h and LDM42A-h)