Astrodesign VG-879 - SDI Configuration Setting Items

Chapter 4 Digital Output Settings (DIGITAL OUTPUT)
93
4.3.6 SDI configuration setting items
This section describes configuration settings for the SDI unit.
Set these settings from MENU > Configuration.
[VM-1876-M5]
Level 1
Level 2
Level 3
Setting item
Setting value
Configuration
SDI
Configuration SDI Setting Time Code
Time Code OFF/ON
0: OFF
Does not insert a time code.
1: ON
Inserts a time code.
Start Time Set
h(0 - 23) :m(0 - 59) : s(0 - 59)
Sets the time of Time Code.
Time Set
Sets the time set in Start Time.
Configuration SDI Setting Clock Delay
Delay Clock1 - 8
Sets the delay on a clock
basis for the SDI signal.
This cannot be set when
SDI output.
Sign: Sign (delay/advance)
0: +
Advances by the clock amount set in Time.
1: -
Delays by the clock amount set in Time.
Time: Sets the time. (Value that is half of the 0 to H period)
[VM-1876-MB]
Level 1
Level 2
Level 3
Setting item
Setting value
Configuration
SDI
Configuration SDI Setting Time Code
VITC Time Code OFF/ON
0: OFF
Does not insert VITC.
1: ON
Inserts VITC.
LTC Time Code OFF/ON
0: OFF
Does not insert LTC.
1: ON
Inserts LTC.
Drop Frame OFF/ON
0: OFF
Does not use drop frames.
1: ON
Uses drop frames.
* Applicable only when 29.97, 59.94 fps.
Start Time
h(0 - 23) :m(0 - 59) : s(0 - 59)
Sets the time of Time Code.
Time Set
Sets the time set in Start Time.
Hold
Pauses the time code.
Reset
Resets the counter to zero for the time code.
Configuration SDI Setting Clock Delay
Delay Clock1 - 8
Sets the delay on a clock
basis for the SDI signal.
This cannot be set when SDI
output.
Sign: Sign (delay/advance)
0: +
Advances by the clock amount set in Time.
1: -
Delays by the clock amount set in Time.
Time: Sets the time. (Value that is half of the 0 to H period)