6. Remove the outer scraper plate from the suspen
sion rail. (PT-80 only/fig. 4-17)
7. Remove the bolts securing the inner wheel to the
hub, then remove the wheel.
(PT-80 only/fig. 4-18, 4-19)
8. Use a pry bar to peel the track over the inner
wheel(s) toward the outside of the machine.
(fig. 4-20)
9. Once the track is off of the front wheel(s), pull the
rear of the track clear of the suspension.
(fig. 4-21, 4-22)
4-7
Rubber Track Loader
4. Maintenance
4-16
4-17
4-18
4-19
4-20
4-21
4-22
To Next Page
Loading...
