Rubber Track Loader
10. Undercarriage Disassembly and Assembly
10-3
Figure 10-7
5. Using pry bars, lift the track off the drive sprocket,
fig. 10-8 and pivot the drive table out 90 degrees, fig
10-9. The drive motor hoses will follow the drive
table, and do not need to be removed.
Figure 10-8
Figure 10-9
! WARNING !
To remove the tracks, the machine must be jacked up and
placed on jack stands sturdy enough to support the weight
of the machine. The manufacturer-approved jack stands
are recommended.
Figure 10-10
1. Lubricate the front and rear 14" wheels with any
good lubricant or a soap and water mixture, fig. 10-
10.
2. Using pry bars, "peel" the tracks off of the front
14" wheels, fig. 10-11.
Figure 10-11
Pivot Bracket Long bolt
To Next Page
Loading...