5 OPERATION
83
Cold Weather Operation
The RT-75 / RT-75HD is designed for operation above -22°F (-30°C). If operating
in lower temperatures, special accommodations must be made. Contact your local
dealer for more information.
When operating in cold climates:
• Minimize idle time. Idling at low temps builds insufficient heat to allow engine
and aftertreatment systems to function properly. Engine damage may result.
• Never allow a machine to idle during transport.
• Use proper oil and fuel grades for conditions (e.g., #1 diesel in cold climates).
• If hydraulic oil temperature does not exceed 100°F (37.8C) during operation,
reduce cooler screen air intake area (e.g., cardboard or similar).
5.4 Surface Preservation
ASV Compact Track Loaders are
designed to minimize ground dis-
turbance while operating on fin-
ished surfaces like turf, however,
care should be taken while operat-
ing on these surfaces to prevent
blemishes from occurring.
Turning poses the greatest risk of surface disturbance during operation. Moving in
a straight line across turf will cause little or no disturbance, whereas tight corner-
ing will most likely cause blemishes.
While working on turf, make gradual turns. (see item A) If space is limited, turn
gradually by moving back and forth until facing the desired direction. (see item B)
5.5 Filling The Bucket
Steps: (see illustration, section 5.1)
1. Lower the lift arms until they rest on the frame.
2. Tilt the bucket slowly forward until the cutting edge engages the ground.
3. Drive the machine forward until the bucket is full of material.
4. Curl the bucket and raise the lift arms simultaneously to break the load free
from the pile.
5. Maneuver the machine clear of the pile and then lower the lift arms, keeping
the bucket curled upward, to approximately 10-12 in. (25-30 cm) above the
ground for transporting.
A
B
5.4-1
RT-75 / RT-75HD US O&M
0405-073 2020-07
To Next Page
Loading...
