5
Handling of plug
WARNING
◇ Supply the instrument with DC24V only
(allowable fluctuation is ±10%).
Short-circuit, smoke, or fire may occur if
other voltages are used.
◇ The AC adapter AD-32 (AD-33 or AD-34)
plug must be inserted into an AC 100-240V
outlet. Other outlets may result in a short
circuit, smoke, or fire.
◇ Do not use a power cable and plug that is
damaged, cut, broken, or altered.
Use may result in fire, electrical shock, or
burn.
For repair service of the power cable and
plug, contact an Authorized ATAGO Service
Center.
◇ Do not cut a plug to extend the power cable
of the AD-32 (AD-33 or AD-34).
CAUTION
◇ Do not insert or pull out the connector and
plug with wet hands.
◇ When disconnecting the power cable of the
AC adapter AD-32, AD-33 or AD-34
(optional) from the AC 100-240V outlet,
remove by pulling on the plug only.
Pulling the cable may damage it, and could
result in fire or electrical shock.
◇ Connect the grounding pin when connecting
the plug of the power cable of the AC
adapter AD-32, AD-33 or AD-34 (optional)
to the AC 100-240V outlet
To Next Page
Loading...
Need help?
General
