Multiple handset use
44
Push-to-talk (PTT)
Make an outgoing call during PTT call
During a one-to-one PTT call, press to get a dial
tone. The PTT call ends automatically.
During a one-to-group PTT call, press on the
initiating handset. The PTT call ends automatically and you get a
dial tone.
During a one-to-group PTT call, press on any one
of the destination handsets. That handset gets a dial tone. The
PTT call continues for the rest of the PTT participants.
End or leave a PTT call
For one-to-one PTT calls, both initiating and destination handsets
can end the PTT call. For PTT calls to multiple handsets, the
initiating handset can end the PTT call. If any one of the
destination handsets leaves the PTT call, the call continues until all
participants or the initiator hangs up.
Press on the handset. The screen shows Push to talk
Ended.
-OR-
Place the handset in the telephone base or charger, then the
handset return to idle mode.
NOTE: After is released, the PTT call remains open for a short
time. If no one presses within ten seconds, the PTT call ends
automatically.
•
•
•
To Next Page
Loading...
Need help?
General
