Appendix
71
Register a handset to your telephone base
1. Before you begin registration, make sure the
handset is out of the telephone base or charger
and shows To register HS, see manual.
2. Put the handset you wish to register on the
telephone base cradle.
3. The screen shows Registering... Please wait and
the light on the telephone base turns
on. If the registration is successful, HANDSET X
Registered appears on the screen (HANDSET
represents the handset name, X represents
the handset number). The handset beeps and
the light turns off. The handset is now
registered with the telephone base.
If registration fails, the system will automatically try to register
again. If registration fails after the third try, Registration failed
appears on the screen for a few seconds, and then To register
HS, see manual. This may take up to five minutes to occur. Please
start again from Step 1.
NOTE: You cannot register a handset if any other system handset is in use.
Adding and registering handsets/headsets/
speakerphones
To register HS,
see manual.
For registration, put the handset on the
telephone base, not the handset charger.
Registering...
Please wait
HANDSET X
Registered
To Next Page
Loading...
Need help?
General
