Getting started
7
Telephone base installation
Install the telephone base, as shown below.
The telephone base is ready for tabletop use. If you want to change to wall-
mounting, see Installation options on page 10 for details.
IMPORTANT INFORMATION
1. Use only the power adapters supplied with this product. To order a replacement
power adapter, visit our website at www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Raise the antenna.•
Plug one end of the
telephone line cord
into the telephone
jack on the back of
the telephone base.
•
Route the power
adapter cord and the
telephone line cord
through the slots.
•
Plug the small end of
the telephone base
power adapter into
the power adapter
jack on the back of
the telephone base.
•
Plug the large end of
the telephone base
power adapter into
a power outlet not
controlled by a wall
switch.
•
Plug the other end of the telephone line
cord into a telephone jack or a DSL filter.
•
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required. The
DSL filter must be plugged into
the telephone wall jack.
Telephone line cord
To Next Page
Loading...
