Answering system
64
Message playback
If you have new messages, you hear only the new messages in chronological
order. If there are no new messages, the system plays back all the messages
(in chronological order).
When playback begins, the total number of messages is announced. Before
each message, you hear the day and time of the recording. If the date and
time are not set, you hear, “Time and date not set,” before playback. After
the last message, you hear, “End of messages.” If the recording time is less
than three minutes, you hear, “Less than three minutes to record,” (see
Message capacity on page 61).
To listen to messages at the telephone base:
Press /PLAY/STOP on the telephone base to listen to the
messages. The system announces the number of messages,
then begins playback. Press /PLAY/STOP again to end the
message playback.
To listen to messages on a cordless handset:
1. When the handset is in idle mode, press
MENU/SELECT to
enter the main menu.
2. Press
MENU/SELECT again to select >Play messages.
If there are new and old messages, press qCID or pDIR
to select >Play new msgs or >Play old msgs, then
press MENU/SELECT.
If there are only new or only old messages, they will
play automatically.
The system announces the number of messages, then
begins playback. The message sequence is shown on the
handset screen. If there are no recorded messages, the
handset screen shows No message and you hear, “You
have no message.”
•
•
>Play messages
Answering sys
p
q
Charlie Johnson
4-Repeat 6-Skip
MSG#
1/3
10:01
AM
ANS ON
3 New messages
10/15
10:01
AM
ANS ON
>Play new msgs
Play old msgs
ANS ON
p
q
To Next Page
Loading...
Need help?
General
