10
Getting started
Installation options
Your telephone base is ready for tabletop use. If you want to mount your
telephone on a wall, use the provided wall-mount bracket to connect with
a standard dual-stud telephone wall-mounting plate. If you do not have this
mounting plate, you can purchase one from many hardware or consumer
electronic retailers. You might need a professional to install the mounting plate.
Tabletop to wall-mount installation
With the upper tabs (marked A) on top, align the holes of the wall-mount
bracket with the studs on the standard wall-mounting plate and slide the
bracket down until it locks securely.
Plug one end of the telephone line cord into the jack on the bottom of the
telephone base and plug the other end into the telephone wall jack (or
DSL filter). Plug the small end of the telephone base power adapter into
the jack on the bottom of the telephone base and plug the other end into
an electrical outlet not controlled by a wall switch. Route the telephone
line cord and the power cord through the grooves at the bottom of the
telephone base, accordingly.
Hold the cords to the side of the telephone base. Align the upper slots on
the back of the telephone base just above the upper tabs of the wall-mount
bracket. Make sure the lower slots of the telephone base are also aligned
above the lower tabs of the wall-mount bracket. Push the telephone base
down and against the wall-mount bracket until it clicks securely in place.
If necessary, bundle the telephone line cord and power adapter cord
neatly with twist ties.
1.
2.
3.
4.
1 2
4
3
Raise the
antenna
To Next Page
Loading...
Need help?
General
