Answering system
65
Message playback
Options during playback
When a message is playing, you can adjust the playback volume, skip, repeat
or delete the message.
When messages are playing on the telephone base:
Press q/VOL- or p/VOL+ to adjust the message playback volume.
Press /SKIP to skip to the next message.
Press /REPEAT to repeat the message. Press twice to hear the
previous message.
Press X/DELETE to delete the message.
Press /PLAY/STOP to stop the playback.
When messages are playing on the handset:
Press PHONE/FLASH to stop playback. The screen shows Call back?, then
press MENU/SELECT, PHONE/FLASH, or /SPEAKER to call back the
caller if the caller’s number is available. If the dialing format used is not
correct, then use the following option to choose the correct dialing format
before calling back the caller.
Press MENU/SELECT to pause playback and show the caller ID
information if available. From here, you can press OFF/CANCEL to
resume playback, press # to show different dialing options (page 51), or
press PHONE/FLASH or /SPEAKER to call back the caller. If you do
not call back within 10 seconds, message playback resumes automatically.
Press qCID/VOLUME or pDIR/VOLUME to adjust the message
playback volume.
Press EQ to adjust the message playback audio quality.
Press 6 to skip to the next message.
Press 4 to repeat the message. Press twice to hear the previous message.
Press MUTE/DELETE to delete the message.
Press 5 to stop the playback.
Press /SPEAKER to switch between speakerphone mode and handset mode.
NOTE: The equalizer stays on the same settings until you change it by pressing EQ .
•
•
•
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
