Installing the MERLIN Identifier System
Connecting the Display to a
MERLIN Telephone
Follow the instructions below to wire MERLIN Identifier Display
units to MERLIN telephones:
Remove the station cord from the back of the MERLIN
telephone and plug it into the MERLIN Identifier Display
jack labeled “LINE.”
1.
2.
3.
1.
Plug one end of the 18 inch, modular cord with RJ45 plugs
into the MERLIN Identifier Display jack labeled “TEL” and
the other end into the jack on the back of the MERLIN
telephone.
Plug the 9 volt 200 milliampere transformer power cord into
the MERLIN Identifier Display port labeled “9V-DC” and the
transformer into an AC power outlet.
The MERLIN Identifier Display should display the following
to show that it is powered on:
MERLIN IDENTIFIER
Connecting the Display to a PC
A PC running a purchased, Windows™-based contact
management software application or asynchronous
communications software can be used to capture Caller ID
information from a MERLIN Identifier Display. The MERLIN
Identifier Displays come with a modular cord and an RJ11-to-DB9
adapter. If your PC’s serial port requires a DB25 connection, you
must purchase a DB9-to-DB25 adapter.
To connect a PC to a MERLIN Identifier Display, refer to Figure 6
and follow the steps below:
Unplug the the MERLIN Identifier Display power cord and
switch off the PC.
18
STEP 5:
Wire the MERLIN Identifier Display Units
To Next Page
Loading...
Need help?
General
