Installing the MERLIN Identifier System
■
One or more MERLIN Identifier Displays, each with a
9 volt 200 milliampere power transformer, a modular
cord with RJ45 plugs, a modular cord with RJ11 plugs,
and a phone mounting bracket or a display wall
mounting and mounting screws
Optional Equipment
If you ordered it, your shipment may also include a serial printer,
two modular cords with RJ45 plugs, an RJ45-to-DB9 adapter, and
an RJ45-to-DB25 adapter.
STEP 2:
Mount the MERLIN
Identifier Control Unit
The MERLIN Identifier Control Unit should be mounted near the
MERLIN Controller—placed on a desk, on a shelf, or mounted on
a plywood sheet attached to the wall studs. If you place the
MERLIN Identifier Control Unit on a desk or shelf, make sure that
you have adequate space to work. If you mount the MERLIN
Identifier Control Unit on the wall, refer to Figure 2 as you follow
the instructions below:
1.
Position the MERLIN Identifier Control Unit on the plywood
surface near the MERLIN Controller and an AC power
outlet, and mark points on the plywood surface for the pilot
holes.
WARNING:
Do not use the supplied mounting screws if you are
mounting the MERLIN Identifier Control directly to the wall
and not to plywood. Instead, use wall fasteners, such as
screws with expansive wall anchors or Molly bolts, to
ensure permanent and secure mounting.
STEP 2:
Mount the MERLIN Identifier Control Unit
11
To Next Page
Loading...
Need help?
General
