Installing the MERLIN Identifier System
STEP 7:
Set Up MERLIN
Identifier Parameters
■
■
■
■
■
■
■
■
■
After the MERLIN Identifier system has been installed, the
following initial system parameters must be set up:
Changing the default administration password
Setting up the telephone lines
Setting up the serial port
Notes on Entering Data
The MERLIN Identifier system simplifies the entry of commands
and database information in the following ways:
Displaying upper-case for all letters, whether you type
them in upper- or lower-case
Employing mnemonic commands that are entered by
typing a single character
Supporting type-over edit mode only (<Insert> key not
supported)
Supporting the <Backspace> and <Tab> keys to position
the cursor
(Administrative PC Only) Supporting a Beginner mode
where prompts and menus are displayed, and an
Advanced mode where menus are displayed only upon
request
(Administrative PC Only) Displaying a menu of commands
when you enter ? or H (for Help)
STEP 7:
Set Up MERLIN Identifier Parameters
27
To Next Page
Loading...
Need help?
General
