Installing the MERLIN Identifier System
Entering the Administration Password
You can access the MERLIN Identifier system administration and
database functions only by entering the administration password.
The password is
IDENTIFIER
until you change it.
■
To enter the administration password, type the password
and press <Enter>.
To prevent others from viewing the password, the MERLIN
Identifier system does not display the password as you
type it.
After you enter the password, the MERLIN Identifier system
displays the menu as shown in Figure 8.
Administrative Display Screen
New Edt Srch Del
F+.-$RZQ
Administrative PC Screen
Merlin Identifier version v1.24
Main command menu:
H(elp) or ?
- print main command menu (this menu)
M(ode)
------ switch between Advanced and beginner modes
N(ew)
------- add an entry to the database
S(earch)
---- find the next entry containing a pattern
R(e-search)
- search again with the same pattern
F(irst)
----- move to first name/number in database
+ or = ------
move to next name/number
. (period)
-- show currant name/number
- (minus)
--- move to previous name/number
E(dit)
------ edit currant name/number
D(elete)
---- delete current name/number
P(rint)
----- print entire database on screen
T(ransfer)
-- send or receive name/number pairs
Z ----------- set system parameters
Q(uit) ------ leave administration mode
<Esc>
------- general process interruption key
$ ----------- display numbe of database entries
Figure 8. MERLIN Identifier Administration Menu
28
STEP 7:
Set Up MERLIN Identifier Parameters
To Next Page
Loading...
Need help?
General
