Installing the MERLIN Identifier System
2.
3.
4.
5.
■
■
Connect one end of the modular cord into the MERLIN
Identifier Display jack labeled “RS232” and the other end to
the jack in the RJ11-to-DB9 adapter.
Connect the DB9 adapter to the PC’s serial port, either
COM1 or COM2.
Start the PC and either the contact management software
application or the asynchronous communications software.
If you use the contact management software
application, follow the manufacturer’s instructions to
set up and operate the software.
If you use your own communications software, set up
the PC’s communications software as a direct
connection with the parameters as given under
“Connecting the Administrative PC” in “STEP 6,” and
start the communications program capture feature.
Reconnect the MERLIN Identifier Display power cord.
STEP 6:
Connecting
Administrative Components
You can administer the MERLIN Identifier system from either an
Administrative Display using a PC Keyboard or from an
Administrative PC running asynchronous communications
software. Refer to Figure 7 as you follow the instructions to
connect your administrative components.
WARNING:
To prevent damage to the MERLIN Identifier Control Unit and
equipment you connect to it, remove their power cords before
connecting them.
STEP 6:
Connecting Administrative Components
19
To Next Page
Loading...
Need help?
General
