■
■
■
4. Before connecting this system, you must inform the local telephone
company of the following:
The telephone numbers you will be using with this equipment.
The appropriate registration number and ringer equivalence
number (REN) which can be found on the back or bottom of the
control unit. [The ringer equivalence number (REN) is used to
determine how many devices can be connected to your
telephone line. In most areas, the sum of the RENs of all devices
on any one line should not exceed five (5.0). If too many
devices are attached, they may not ring properly.]
When this equipment is permanently disconnected from the line(s).
Port ID
REN/SOC
FIC
USOC
MERLIN
0.0B/9.0Y
02LS2
RJ11C
Identifier
Always connected in parallel with
MERLIN Phone System
5. Repairs to this equipment can be made only by the manufacturers, their
authorized agents, or by others who may be authorized by the FCC. [In
the event repairs are needed on this equipment, please contact the
AT&T National Service Assistance Center (NSAC) at 1 800 628-2888 or
your authorized AT&T dealer.]
Canadian Department of Communications (DOC)
Interference Information
This digital apparatus does not exceed the Class A limits for radio noise
emissions set out in the radio interference regulations of the Canadian
Department of Communications.
Le Présent Appareil Numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de la class A
prescrites dans le Règlement sur le brouillage radioélectrique édicté par le
ministère des Communications du Canada.
To Next Page
Loading...
Need help?
General
