AT&T SB67108 - Belt Clip and Optional Headset

12
Getting started
Belt clip and optional headset
Install belt clip as shown below if desired.
Snap the belt clip
into notches on
both sides of the
handset.
To release the belt
clip, pull and unlock
one flap from the
notch first before
detaching the whole
belt clip from the
handset.
To use an AT&T 2.5 mm headset, plug it into the jack on the side of the
handset as shown below.
Plug the 2.5 mm
headset into the jack
on the side of the
handset (beneath the
small rubber flap).